Z-Wave MIMO2 Multi-Input Multi-Output Module

$ 79.99

Provides TWO inputs and TWO relay outputs.  Inputs can include reed switches, contact sensors, door bell buttons. security panel relay's water leak probes, water level sensors, temperature probes, float switches, etc.  Outputs can control garage doors, motorized shades, gates, valves, etc.  Relay output can be set for momentary or latching.

Check out our Z-Wave™ Water Shutoff Valve Package Deal!

Overview

Make virtually any device speak Z-Wave™!

* Connect up to four wired devices to Signal inputs and make them wireless.

* Connect them functionally to your Home Security panel OR to your Z-Wave™ home automation network

* Connect high or low 16V digital signals

* Connect pulse reading devices

* Connect analog signals

The MIMO (Multiple Input - Multiple Output) Module is an interface/bridge module, capable of converting up to two digital & analog voltage & pulsesinputs and/or a Z-Wave™ RF message input to one or two dry contact relay outputs and/or a Z-Wave™ RF message output. The MIMO is Z-Wave™ Wireless device compatible with other Z-Wave™ certified products.

Specifications

Power: 12 to 16 volts DC from regulated Power supply @~ 500mA capability

Frequency Range: 908.4MHz (US); 868.4MHz (EU)

Distance Range: Max 100ft line of sight in unobstructed environment

PCB Size (LxW): 2.68" (68mm) x 3.7" (94mm)

Enclosure Size (LxWxD): 4.53" (115mm) x 3.54" (90mm) x 2.16" (55mm)

Weight: 6 OZ (170 gram)

Operating Temperature: -10⁰C (14F) to +70⁰C (158F)

Input Signal 1 & 2 (SIG1 & SIG2): Digital or Analog Input 0 to 16V DC or 16 Hz Max for pulse counting (minimum 32 ms high or low time). The trigger levels and hysteresis can be set via the

Configuration Command Class for the two endpoints.
0V to 1V -- considered a Digital LOW
1V to 1.45V -- considered gray area, hysteresis
1.45V to 16V -- considered a Digital HIGH

Input Signal Impedance Input IMPEDANCE for any of the MIMO signals Z=66 ohm at 10KHz . This impedance is = 66 ohm = 34 ohm + j540uH. (Refer to Technical Appendix for characteristic Smith / S11 charts.)

Output Relay 1: DPDT, Max. Switching power of 62.5 VA or 60W; 10uA to 2A; High Dielectric strength coil-contacts: 1,000 VAC;

Open contacts: 750 VAC; Conforms to FCC Part 68 requirements; Ag + Au clad bifurcated contacts fully sealed.

Output Relay 2: DPDT, Max. Switching power of 62.5 VA or 60W; 10uA to 2A; High Dielectric strength coil-contacts: 1,000 VAC;

Open contacts: 750 VAC; Conforms to FCC Part 68 requirements; Ag + Au clad bifurcated contacts fully sealed.

System Requirement: Any Z-WaveTM -enabled network and controller.

Innovative Home Systems is an Upfront Merchant on TheFind. Click for info.