Z-Wave ON-Off Wall Switch WS100 (Open Box)

• Pin It

ZWP Model # WS100 Non-dimming Wall Switch

Overview

Works with incandescent lamps, florescent, and LED lighting

Fits standard wall plate, user replaceable keypad to match colors

Clean design with LED status indicator

GROUP/SCENE/ALL enabled

Over-The-Air firmware upgrade supported with Z-Wave™ static controller, PC and software

Supports Network Wide Inclusion

Powered by Sigma Design 500 Series module inside

Internal resettable fuse to protect from surge current

Functions as a Z-Wave™ signal repeater

See our PA-100 plug-in non-dimming switch which plugs into a standard AC outlet, and allows remote control of On, Off lights and AC operated appliances. It also repeats Z-Wave commands to other devices.

Specifications

Parameter                                Min    Nom   Max  Unit

Operating Temperature             0                  40     °C

Storage Temperature               -20                60     °C

Storage Humidity                                           80      %

Electrical Ratings:

Input Voltage                           108     120     132 Volts

Input Frequency                       57       60       62    Hz

Maximum Output Load : 900W incandescent, 200W CFL/LED, ½ horsepower motor, and 15A, 1800W resistive load

Fuse                                                              5  Amps

Dimmer conduction angle

at max fully on position           80       90                %

Z-Wave™ Frequency for USA       908.42 MHz at 9.6 kps      -0.025 908.42 +0.025 Mhz

Wireless Range (controller & repeater)

at open air, 1 meters high,               100              ft

Modulation              FSK

Tx Power from IC setting                  -1             dbm

Rx Sensitivity                                  -102           dbm

At 40kps                                            -98           dbm

Standby current                                  25           mA

Mechanical Parameters  

Dimensions Body: 2.8"x1.71"x1.41" Yoke: 4.13"x2.13"x.076" Inches

Wire Terminals:  Line, Load, Traveler,Neutral

Minimum Hole for Wire:    Accept #10 AWG

Wire Type: Copper Only

Clamp Parts:  Copper or plated aluminum

Primary Color: Munsell N9 Apple White

Body Material:  GE Pplastic,lexan Resin 940

Agency Listing and Certifications:

FCC and Industry Canada:  X

UL Listed, US Canada:  X

Z-Wave™ Plus Certified: X

Special Feature: Traveler connection is protected against improper hookup to line, load, ground, neutral.

Supplied Parts:

Mounting Screws     Qty=2

Instruction manual    Qty=1